- Deficiency of video cards AMD makes miners look at GeForce GTX 1060 - GeForce GTX 1080 Ti on the core frequency of 2770 MHz updated the record GPUPI 1B - In the new architecture of processors, Intel abandoned the internal ring bus - EVGA claims that the gilding of the printed circuit board allow to lower its temperature -

	xtreview is your : Video card - cpu - memory - Hard drive - power supply unit source

POSTER: computer news   ||    DEFICIENCY OF VIDEO CARDS AMD MAKES MINERS LOOK AT GEFORCE GTX 1060	DATE:2017-06-16
We see almost every day evidence of NVIDIA's interest in the production of special boards based on GP106 GPUs (GeForce GTX 1060), which are suitable only for speeding up calculations and extraction of the so-called "crypto-currency".  However, as the resources of Fudzilla and AKIBA PC Hotline note in one voice, the GeForce GTX 1060 gaming graphics cards are still far from the popularity of the Radeon RX 580/570 and Radeon RX 480/470 among the supporters of the new form of "social support". AMD video cards remain in deficit, and the situation is unlikely to change in the coming months, as graphics card manufacturers are either not ready to increase the volume of output, or are afraid to once again remain with overstocked warehouses.  If small batches of popular "mining tools" appear in stores, they are immediately sold out in the same lots, as a rule.  The focus of attention of the target audience is shifted to the GeForce GTX 1060, which is still easier to buy at same prices.  Japanese colleagues also confirm that the jump in demand for power units with a capacity of more than 1 kW, which are used to create "farms" by participants in "crypto-currency ," also caused a shortage of components of this type. Select Rating : Currently 10.00/10 1 2 3 4 5 6 7 8 9 10 49006 Rating: 10.0/10 (10 votes cast) Deficiency of video cards AMD makes miners look at GeForce GTX 1060	Add Comment ( 1 ) DEFICIENCY OF VIDEO CARDS AMD MAKES MINERS LOOK AT GEFORCE GTX 1060

POSTER: computer news   ||    GEFORCE GTX 1080 TI ON THE CORE FREQUENCY OF 2770 MHZ UPDATED THE RECORD GPUPI 1B	DATE:2017-06-16
Yesterday, the video card GeForce GTX 1080 Ti in GALAX / KFA2 had to overcome the GPU frequency of 2.8 GHz to take the first place in GPUPI 1B , and today the top of the rating was taken by the Greek enthusiast OGS , which was obtained at lower graphics card frequencies - 2770/10000 MHz .  We used exactly the same graphics card, whose graphics processor was cooled by liquid nitrogen.   GPUPI 1B calculation is executed for 8.389 seconds, which is a new record among single video cards.  The frequency of the processor Core i7-7700K in this case did not exceed 4.5 GHz, it did not influence the final result, and therefore Kaby Lake-K was satisfied with the air cooling system. Select Rating : Currently 10.00/10 1 2 3 4 5 6 7 8 9 10 49005 Rating: 10.0/10 (9 votes cast) GeForce GTX 1080 Ti on the core frequency of 2770 MHz updated the record GPUPI 1B	Add Comment ( 1 ) GEFORCE GTX 1080 TI ON THE CORE FREQUENCY OF 2770 MHZ UPDATED THE RECORD GPUPI 1B

POSTER: computer news   ||    IN THE NEW ARCHITECTURE OF PROCESSORS, INTEL ABANDONED THE INTERNAL RING BUS	DATE:2017-06-16
In March, Intel showed an image of a 28-core crystal processor Skylake-SP.  Then we noticed that the location of the cores and interfaces has undergone significant changes.  Yesterday at Intel at one of the home events explained what these design changes are related to.  As it turned out, in the future Intel will refuse (and has already refused for Skylake processors in versions of Xeon and desktop solutions of higher performance) from the internal processor ring bus. The ring bus was introduced in 2008 together with the Nehalem architecture and the Westmere-EX processors.  It was necessary in connection with the increase in the number of core on the crystal.  The developers of Intel used three variants of the design of the processors (depending on the maximum number of cores on the chip) with three variants of the ring bus.  In the most difficult case, the processor inside was divided into two clusters, each of which was serviced by two ring buses.  Between each other, the buses were connected by bi-directional switches with buffering (in the diagram above they are indicated in gray). As the number of core increases, the ring bus has become an obstacle to increasing the capacity and reducing delays.  More precisely, it has become too much to consume, so that it can be scaled in the direction of increasing the speed of data exchange.  Therefore, in the Skylake-SP processors, Intel developers decided to use a different structure for connecting the cores to each other - a well-tested cellular network in the Intel Xeon Phi (Knights Landing) architecture.   Each core in the new architecture has its own switch with a buffer and is connected to any other core within the processor only through two nodes - outgoing and incoming.  This allows the mesh bus to operate at relatively low frequencies and significantly reduce the total interface consumption without degrading bandwidth and increasing latency.  In addition, this communication structure scales very well, allowing Intel to increase the number of cores on the chip in the future without a noticeable increase in the energy costs for internal data transport. Clarifying the essence of the new internal bus, as well as the appearance of the image of the 18-core processor with a new design, also makes it possible to ensure that the new processors do carry an integrated 6-channel memory controller, which is now spread around the edges on the crystal just above the middle.   Select Rating : Currently 10.00/10 1 2 3 4 5 6 7 8 9 10 49004 Rating: 10.0/10 (6 votes cast) In the new architecture of processors, Intel abandoned the internal ring bus	Add Comment ( 1 ) IN THE NEW ARCHITECTURE OF PROCESSORS, INTEL ABANDONED THE INTERNAL RING BUS

POSTER: computer news   ||    EVGA CLAIMS THAT THE GILDING OF THE PRINTED CIRCUIT BOARD ALLOW TO LOWER ITS TEMPERATURE	DATE:2017-06-16
EVGA recently presented the promised video card GeForce GTX 1080 Ti K | ngp | n Edition, which was developed at least two months.  The device of the power system did not meet the expectations of some readers, but there is no doubt that the product will be actively used in experiments with extreme overclocking - first of all, with the direct participation of Vince Lucido, whose "operative pseudonym" gave the name to the novelty. Resource Gamers Nexus published a video interview with the creators of this video card, among which, and seen working in EVGA engineer of Ukrainian origin, Ilya Tsemenko (TiN).  Companions explain why the gold coating of individual areas of the printed circuit board was used - it allows more efficient removal of heat.  The temperature of the PCB was reduced by five degrees Celsius, according to EVGA representatives.  All layers of the printed circuit board communicate with the "gilding" just to achieve this goal. Select Rating : Currently 10.00/10 1 2 3 4 5 6 7 8 9 10 49003 Rating: 10.0/10 (5 votes cast) EVGA claims that the gilding of the printed circuit board allow to lower its temperature	Add Comment ( 1 ) EVGA CLAIMS THAT THE GILDING OF THE PRINTED CIRCUIT BOARD ALLOW TO LOWER ITS TEMPERATURE

	xtreview is your : Video card - cpu - memory - Hard drive - power supply unit source

computer news computer parts review OLD Forum Downloads New Forum Login Join Articles terms Hardware blog Sitemap myspace proxy Get Freebies