AsRock NForce3

HI There ; Do you find this message annoying? Why not make a post and get rid of it ?

[Zaarco]

I have an AsRock NForce3 Motherboard with Sempron 2800+ (working at 1600 Mhz as default)
I tryed to overclock it to 2400 Mhz(300*, and worked stable, with prime 95 until 12 hours without problems

But the problem is the FSB value is set to default (200) after a littletime, without crashing

There is any issue ? Someone had this problem ?

Thanks

[Xtreview]

1-) The system is at its limit , and bios revert back to default setting.
2-) check your psu
3-) Try a bios update this can help 

[Zaarco]

1-) The system is at its limit , and bios revert back to default setting.

Can this happen without an error, i mean this happened when i turned off my pc and turn on

2-) check your psu

I have a true power 380W PSU, i don't think that something wrong with it, i monitored values and seems working fine

3-) Try a bios update this can help 

I have the last Bios version , may be a downgrade will resolve this Issue

Thanks for advise

[Xtreview]

Most likely their was a bios crash.
Try again , restore your overclocked setting and check for stability.
If your system still stable then i are OK.